tito
Más ideas de tito
Next drill a hole through the face of the block of a diameter to match that of the cutter you are going to use to form the dowel

Next drill a hole through the face of the block of a diameter to match that of the cutter you are going to use to form the dowel

With this in place feed the dowel back into the outfeed hole and adjust the cutter up to cut the required tenon diameter

With this in place feed the dowel back into the outfeed hole and adjust the cutter up to cut the required tenon diameter

Wind the cutter up until the tip just lines up with the diameter of the outfeed hole

Wind the cutter up until the tip just lines up with the diameter of the outfeed hole

I also realised that the square section was also slightly undersize and was rattling about slightly in the infeed hole

I also realised that the square section was also slightly undersize and was rattling about slightly in the infeed hole

This was improved a lot when I waxed the inside of the outfeed hole to make the emerging dowel slide more freely as it also allowed me to drop the cutter fractionally and make the fit correspondingly tighter

This was improved a lot when I waxed the inside of the outfeed hole to make the emerging dowel slide more freely as it also allowed me to drop the cutter fractionally and make the fit correspondingly tighter

Now bolt this block to the middle of the support strip, having first drilled a central opening to allow some leeway when you are setting it up on the table

Now bolt this block to the middle of the support strip, having first drilled a central opening to allow some leeway when you are setting it up on the table

There are just two holes in this one. The side one is the same diameter as the dowel again while the one on the face is any size that is big enough to enclose the ovolo cutter

There are just two holes in this one. The side one is the same diameter as the dowel again while the one on the face is any size that is big enough to enclose the ovolo cutter

Wind the cutter up until the tip just lines up with the diameter of the outfeed hole

Wind the cutter up until the tip just lines up with the diameter of the outfeed hole